Installation Instructions For LPG Pressure Regulator

Jul 21, 2022

Leave a message

During the installation of LPG pressure regulator, careful and regular operation is required. The specific installation requirements are as follows:

1. Before the installation of LPG pressure regulator, the pipeline shall be pressure tested and purged to ensure the tightness and cleanness of the pipeline.

2. The LPG pressure regulator shall be installed on the pipeline horizontally and vertically. In addition, attention shall be paid to ensure that the flow direction of the medium in the pipeline is consistent with the direction of the arrow on the valve body.

3. Control ball valves shall be installed on both sides of the LPG regulator, and bypass pipes shall be installed for maintenance.

4. Pressure gauges shall be set on the high and low pressure pipelines of the LPG pressure regulator to facilitate adjustment and observe the pressure changes before and after the valve during operation.

5. A safety relief valve is set on the pipeline to ensure the reliability and safety of the operation of the LPG pressure regulator.

6. The indoor gas pipeline shall be equipped with a gas leakage alarm device indoors to ensure that when the gas leakage is dangerous, it can timely alarm and eliminate the danger.

7. In order to ensure safe use, after the LPG pressure regulator is installed, the tightness must be tested. The leakage detector can be used at all pipe joints or the soapy water and detergent water can be brushed for inspection to observe whether there is air leakage. If a pressure gauge is installed in front of and behind the pressure regulator, close the air source and observe whether the pointer changes.